It\'s nice to see some of these parts assembled at last. When I\'ve got my chuck key back I\'ll finish the barrels as well and fit them. I also marked out the barrels where they need to be turned down with a taper. 22 rims catch on some of the grooves of the pan, so some additional filing will be required for that as well. I noticed that the bolts dont all slide into the Pan nicely, so a bit of additional filing is required, but I wont do that until I\'ve got all 10 bolts done and rotate the pan for best fit. I put the five finished bolts in the assembly as well as three inert. It\'s a fairly good start to the barrel assembly being completed. Here\'s a photo of the Pan, the bolt carrier, the main shaft and driven gear. I didn\'t get a photo of it as it\'s not quite finished yet. I bored the center hole out though, so at least it fits onto the assembly now. Ok, so I went downstairs to machine the last few operations on the pan, and can\'t find the chuck key for the lathe.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. Archives
March 2023
Categories |